Buy a Corning miniMASS ribbon splicer to take full advantage of those big fiber splicing opportunities. This German made ribbon splicer is built like a tank and has been a workhorse for 25 years.
Splice 12-fiber ribbons in about 10 seconds with an average 0.04 dB loss rather than slitting them, doing 12 individual splices while consuming twelve protection sleeves where one will do.
Our Corning X75 / C752 Ribbon Splicer kits include:
Questions?
Call us at: 512-686-0469
Available Tuesday thru Friday
7:45 am to 6 pm, Central Time
Orders received before 3:00pm CST Tuesday thru Friday will ship same day.
Run into a snag?
Not likely with the toughest ribbon splicer ever manufactured; but if you do, our fleet has depth.
Priority repair services available and exchange units are always ready to ship at a moment’s notice.
Our splicer fleet has gone many directions over the last 20 years before settling on an exclusive miniMASS stable. As you might imagine, our TyroLab services laboratory has processed dozens of splicers every week since 2002 - and we’ve seen them all - Sumi’s, Fuji’s, Fitel’s, ericsson’s, Siecor/Corning, and even the latest of Korean and Chinese entries.
One very small jewel sets the miniMASS C752 apart when it comes to repeatability and unbeatable ribbon splicing, the V-groove block.
The C752's block uses an exclusive precision polished, etched glass ribbon guide to precision align the ribbon fibers fibers into fusing position. Being etched glass it is difficult for strand contamination or even icky-pic to fuse into the grooves.
Our technicians are able to refresh the block every visit with 99% isopropyl alcohol and micron bristled fiberglass sweeps. This precise guide is the only design that ensures your last splice is as good as the first.
Cleaning is the staple of splicing, stay away from splicers that the V-grooves can’t be cleaned without scrubbing (ceramic), or worse, nylon or plastic that will the inevitably become scratched or burnt with standard use.
A degraded performance from your splicing tool originates with machine design to handle the fiber(s). I’m sure they worked quite well out of the box -- but, compare results to a miniMASS after a couple hundred splices and it is obvious why repeatability is not a new equipment data sheet spec.
Plastic or nylon V-grooves are not an investment, they are a manufacturing cost reduction to get you past that first year of use, and ALL models of both core and V-groove alignment splicers rely on accurate V-grooves to bring the fibers together.
V-Groove Blocks of the C752 miniMass
Tyrosys Corp | FiberSplicer.com | FiberSplicer.store
Office Phone: 512-686-0469
Tyrosys Corp
10921 E Crystal Falls Pkwy, STE K-800
Leander, Texas 78641
Toll-free: 1-877-TYROSYS (1-877-897-6797)
Fax: 903-640-4951
Office Hours: 7:45am to 6:00pm (CST)
Tuesday thru Friday
FiberSplicer.com is the fiber optics division of Tyrosys Corp
Copyright © 2002 - 2023 Division of Tyrosys Corp